After a concrete slab is lifted, how do you know where void filling is needed?
First establish what moved, what the slab is supposed to bear on, and where contact with the supporting material was lost. A gap at one exposed edge establishes a gap at that location. It gives no reliable measure of the area or depth of empty space beneath the rest of the slab. The evaluation changes if the concrete supports a wall, bridges between supports by design, or is an independent patio beside a house.
Separate the footing from the slab
Ask the contractor to sketch a section through the wall, footing and floor. In one arrangement the wall is lifted on supports while a separate slab stays on the soil. In another, lifting part of the concrete carries the slab upward with it. The visible separation can look similar at an edge. The load path and the appropriate location for any fill can be quite different. A structural slab with intentional clearance below requires a design review before that clearance is filled.
Find out why contact was lost
The gap may have existed before the repair. Water can remove soil near a leaking drain or a concentrated discharge, or poorly consolidated fill can settle after a slab is cast. The lift itself can also move concrete away from soil that stays in place. Pre-lift photos, elevation readings and the repair sequence help distinguish these explanations. If soil is still being lost, the proposal should address the source and say how it will be checked after repair.
What each observation can establish
- Visible edge and joint conditions. Note where a gap starts and stops, whether adjoining sections move differently, and whether a wall or utility crosses the area. Avoid reaching into or crawling under raised concrete.
- Surveyed elevations. Readings from stable control locate surface changes and can reveal unwanted rise during filling. Elevation alone cannot measure the hidden depth of a cavity.
- Subsurface investigation. Where justified, a specialist may recommend scanning or a targeted inspection opening after checking for embedded services, reinforcement and tendons. Ground-penetrating radar has detection limits, including interference from steel mesh. Ask what the chosen method can distinguish on this slab. FHWA on radar applications and limitations.
Compare the proposed outcomes
If the slab is already at the intended height, the work may call for restoring contact while limiting additional movement. If the slab still requires lifting, the target elevations and the effect on adjacent work belong in the scope. If the slab is broken into poorly supported pieces, reconstruction may give better access to correct the base. A proposed grout or foam quantity alone does not tell a homeowner which outcome is being purchased or where material will travel.
The Federal Highway Administration’s pavement preservation guide distinguishes void filling from raising concrete and describes checking for unintended rise. Its highway test values and acceptance criteria are specific to that application. For a house, ask for the monitoring method, stopping criteria, protection of drains and utilities, and an agreed way to evaluate the result afterward. Load-bearing or post-tensioned slabs, unexplained washout, or unknown concealed construction warrant a licensed engineer’s assessment before drilling or injection. FHWA Concrete Pavement Preservation Guide, chapter 4.
If a void appeared during foundation lifting or house leveling, call Home Remodel Specialist at 541-543-8328 for a free Oregon estimate. Tell us whether the affected area is a patio, garage floor or part of the house foundation, and share the original lift scope if available.
