Oregon foundation repair & home remodelingCCB #227476 Se habla español
541-543-8328Free estimate
← Oregon foundation repair questions

A crawlspace beam has a joint near a post. How can an inspector tell whether the splice is supported?

Look at where the wood actually ends relative to the usable bearing surface. A joint can appear directly above a post from one side while one beam end misses the cap or an outer ply hangs beyond its edge. Conversely, two separate lengths can each bear on a properly detailed shared support. Location is the first observation. The required bearing, connections and whether the design depends on continuity are separate questions.

Draw the support in plan view

Sketch the beam as several parallel plies viewed from above. Draw the actual outline of the post top or steel cap underneath. Mark visible joints on their individual plies and measure each against the nearest edge of the bearing surface. A drawing of a single line labeled “splice” can hide an interrupted outer ply and an apparently continuous inner one. Where the inner ply is concealed, leave its line marked unknown. Photograph the underside as well as the beam face from accessible locations.

Identify how the load enters. Joists hung from one face deliver load first to the outside ply, making the specified inter-ply connections relevant. Underneath, note contact, tilt, crushed wood, a displaced cap or a gap under either end. A square-looking post cannot establish the condition of a footing hidden below grade. Note any visible distortion above, but do not use the absence of a sag to assign a load rating.

Why staggered joints deserve a closer look

Staggering the seams leaves other plies alongside each interrupted piece. It does not establish that those plies and their fasteners can transmit the forces at the interruption. Weyerhaeuser illustrates the problem with a three-ply beam built from staggered lengths. Its technical guidance calls for design review of a splice within a span. Also ask whether drawings specify separate simple spans or a member continuous across supports. A joint over a sound post can still change the behavior of a beam designed to run continuously past it. Trus Joist guidance on multiple-member beam splices.

Example inspection wording

At the crawlspace post beneath the hall, the near beam ply has a butt joint beyond the visible edge of the steel cap. The inner ply and far face were concealed. Obtain the beam layout and any splice detail. Have a licensed structural engineer evaluate this interruption and the available bearing before the bay is enclosed.

If the joint has slipped or the wood is crushing, request prompt assessment and avoid adjusting the post. For an Oregon beam or post repair estimate, call Home Remodel Specialist at 541-543-8328.

Request a free estimate ↗
© 2026 Home Remodel Specialist · OregonPrivacy & project inquiries
Call usRequest an estimate