Oregon foundation repair & home remodelingCCB #227476 Se habla español
541-543-8328Free estimate
← Oregon foundation repair questions

If a bearing wall is replaced with a beam, can its new end posts stand on the existing basement slab?

Only if the supporting construction at each proposed post has been verified as adequate for that post’s load. A basement can have a thin slab between separate structural footings, a thickened slab at selected locations, or a specifically designed structural slab. From above, all three may look like one uninterrupted floor. An uncracked finish and a correctly sized beam do not establish what can carry its end reactions.

How removing a wall changes demand below the floor

A bearing wall may distribute weight along a line. A beam spanning the new opening delivers much of that load to a small number of supports. An end post can introduce a concentrated force where the old wall carried much less load over the same footprint. Even if the combined gravity load on the house barely changes, its location and distribution can change significantly. Roof framing or a post on the floor above can also make the reactions at the two ends unequal.

Follow each end independently

On the drawing, mark both ends of the new beam and carry those locations down through every floor. At one end there may be a foundation wall. At the other there may be a framed floor, an offset basement partition or a slab poured over fill. If the proposed post appears to line up with a beam below, ask whether that lower beam and its supports were evaluated for the additional load. A small offset matters where it changes how the force reaches the support.

Which field evidence makes the bid comparable?

  1. Ask for the basis of the proposed beam reactions and which loads are included. Clarify whether the wall also has a lateral bracing function that needs separate evaluation.
  2. Ask what establishes the existing footing or slab configuration under each post. Available plans, verified field dimensions and investigation selected by the designer can answer different parts of that question.
  3. If a footing is assumed but concealed, identify who checks it, when the check occurs, and the price and scheduling implications if the assumption fails. A post base connector does not establish concrete thickness, reinforcement or soil support beneath it.
  4. Ask who addresses temporary support during demolition, buried utilities, concrete restoration and inspections before concealment.

In Portland, the city provides guidance on residential plan drawings, including what a foundation plan shows. Have the project designer and permitting office identify the submittals for the particular alteration. Keep engineering, permits, investigation and restoration visible in competing prices. Avoid beginning demolition before the load path and temporary support have been addressed.

Portland residential building-plan guidance. For a free Oregon estimate, share the proposed opening and any plans for the floor below. Beam and post repair services · 541-543-8328.

Request a free estimate ↗
© 2026 Home Remodel Specialist · OregonPrivacy & project inquiries
Call usRequest an estimate