Oregon foundation repair & home remodelingCCB #227476 Se habla español
541-543-8328Free estimate
← Oregon foundation repair questions

Is water coming through a basement form-tie hole or a crack in the poured concrete wall?

Look for the first place fresh water appears on the exposed concrete. A bead forming at one recess in a repeating pattern of form ties supports a local tie-path leak. Water appearing along a continuous fracture, particularly beyond the recess, warrants a crack investigation. A crack can intersect a tie location, and the wet face alone cannot prove the path through the wall. A photo taken after a whole section has become wet may capture only the runoff.

Identify what the wall surface actually shows

Form ties hold the two sides of the forms in position while concrete is placed. Depending on the system and finish, the wall may retain small regularly spaced recesses or patches at the tie points. Locate several neighboring marks, then photograph the wet one in relation to that pattern. A vertical form-panel imprint may be visible without being an open crack. Mark where a visible fracture starts and ends, whether it crosses a patch or panel line, and whether a step can be seen or measured across it. Tie holes, construction joints, cracks and pockets of poorly consolidated concrete can each transmit water. BC Housing, moisture pathways in poured-in-place residential concrete.

Capture the next wet event

From a safe, accessible area, note the time relative to rainfall and whether the wall was dry beforehand. Give the wet point a reproducible location, such as height above slab and distance from the nearest corner. Photograph the first bead with a scale beside it, then the later stain. Check above it for pipe penetrations, a window or a sill that could send water down the surface. If finishes hide the concrete, identify that limit. Someone may need authorized access to the substrate before specifying injection.

Compare the corresponding exterior area with roof runoff, grade and downspout discharge. Rain-linked wetting can justify that investigation even if the foundation face is buried. A local tie repair can close one opening while water continues to collect against the wall. Conversely, a working drain does not eliminate every possible defect at a penetration. Ask how the proposed repair addresses the observed entry and how the team will check it after comparable rain. University of Minnesota Extension guidance on basement moisture sources.

Example inspection note

Illustrative wording: “East poured-concrete wall, 4 feet north of the corner and 28 inches above the slab. A fresh bead formed in one circular recess matching the neighboring tie pattern. A vertical stain extended 10 inches below. No continuous open fracture was visible on the exposed interior face. Exterior face below grade was inaccessible. Recommend evaluating discharge above this area and inspecting the tie detail before selecting a seal.”

If the wall face shows progressive offset, bowing, loose concrete or movement near a beam seat, request structural engineering review before covering it. For a free Oregon estimate, send a wide wall photo, close-up and weather timing to Home Remodel Specialist’s foundation crack repair team or call 541-543-8328.

Request a free estimate ↗
© 2026 Home Remodel Specialist · OregonPrivacy & project inquiries
Call usRequest an estimate